B.u.d.s. Programming - BRP Can-Am Spyder RS 2011 Series Predelivery Bulletin

Have a person of approximately the same weight
as the driver taking place on the vehicle.
Select high beam.
Beam aiming is correct when the focus point of
headlight reflection is between upper marks.
1
C
D
rmo2008-027-105_b
HEADLIGHT REFLECTION ON TEST SURFACE — HIGH BEAM
1. Focus point
A. 828 mm (32-19/32 in) above ground
B. 738 mm (29-1/16 in) above ground
C. 464 mm (18-9/32 in) above ground
D. 374 mm (14-23/32 in) above ground
Select low beam.
Beam aiming is correct when the focus point of
headlight reflection is between lower marks.
A
B
rmo2008-027-104_b
RH TRAFFIC HEADLIGHT REFLECTION ON TEST SURFACE —
LOW BEAM
1. Focus point
A. 828 mm (32-19/32 in) above ground
B. 738 mm (29-1/16 in) above ground
C. 464 mm (18-9/32 in) above ground
D. 374 mm (14-23/32 in) above ground
rbl2009-001-008_b
LH TRAFFIC HEADLIGHT REFLECTION ON TEST SURFACE —
LOW BEAM
1. Focus point
A. 464 mm (18-9/32 in) above ground
B. 374 mm (14-23/32 in) above ground
PREDELIVERY
A
B
C
D
1
A
B
1
For LH traffic country application, low
NOTE:
beam headlights must have been replaced as
described in this predelivery bulletin.
High Beam
Turn adjustment screws to adjust beam height.
Adjust both headlights evenly.
rmr2008-027-102_a
ADJUSTMENT SCREWS
Low Beam
Insert a long Phillips screwdriver into air duct to
reach the adjustment screws.
rmr2008-027-106_a
1. Air duct
2. Screwdriver
Turn adjustment screws to adjust beam height.
Adjust both headlights evenly.

B.U.D.S. Programming

Always use the latest B.U.D.S. version on your
shop computer. At time of printing, the latest
B.U.D.S. version is P2.3.29. It is available from
the following web site:
WWW.BOSSWEB.BRP.COM
2011-1
ADJUSTMENTS
23 / 32