Uncrating; Crate Cover Removal; Sub-Crate Removal; Parts Check - BRP Can-Am Spyder RS 2011 Series Predelivery Bulletin

UNCRATING

UNCRATING

Crate Cover Removal

NOTICE Allowing the crate to drop may cause
serious damage to vehicle.
1. Position the crate on a firm, level surface.
2. Carefully cut both ends of crate tarpaulin to lo-
cate the rear of vehicle.
rbl2010-002-001
CUT BOTH END OF CRATE TARPAULIN
3. Remove all screws holding crate cover to crate
base.
4. Tilt cover from the rear side of the vehicle.
NOTICE Do not raise cover vertically. Tilt
cover located on the rear side of the vehicle.
Refer to illustration.
rbl2010-002-002
TILT COVER THEN PULL IT
NOTICE The crate cover must be pulled to-
ward the outside while lifting it to avoid to
damage vehicle.
Screws that are used are Robertson
NOTE:
type (or equivalent) that require the use of an ap-
propriate screwdriver.
† Robertson is a registered trademark of Robertson Inc.
4 / 32

Sub-crate Removal

NOTICE Be careful not to scratch the cover
bumper and the front fascia.
The sub-crate is located on the left side of
NOTE:
vehicle and it contains the front storage compart-
ment.
1. Remove protective foam from vehicle.
2. Remove all screws holding sub-crate to crate
base.
3. Assisted by another person, carefully lift up the
sub-crate.
rbl2008-003-300_a
1. Sub-crate

Parts Check

Ensure that the crate includes the following items
(inside front storage compartment):
DESCRIPTION
Operator's
guide
Predelivery
check list
Safety DVD
Predelivery kit
Service center
panel
Mudguard
Wheel caps
The predelivery kit should included the following
items:
† #2
2011-1
MODEL QTY
1
1
1
All
1
1
2
2
PREDELIVERY