Remote Control Unit Group Settings - Furuno NAVnet TZtouch2 Operator's Manual
Multi function display
Hide thumbs
Also See for NAVnet TZtouch2:
- Setup procedures (19 pages) ,
- Operator's manual (17 pages) ,
- Software update procedure (12 pages)
Table of Contents
Advertisement
1.2.4
Remote Control Unit group settings
If multiple NavNet TZtouch2 units are installed in the network, you can the select the
display to show on a unit, using the MCU-004 or MCU-005. Additionally, you can se-
lect the order in which to cycle through the displays.
Note: Confirm that there are no duplicate unit nicknames in the network. If a duplicate
name is found, change the name on the Sensor List ([Initial Setup][Sensor List]).
1. From the Home page, select [Settings][Initial Setup].
2. Tap the item [Remote Controller Configuration] twice.
No.
1
The nickname automatically assigned to the MCU-004/MCU-005.
2
The nickname assigned to the NavNet TZtouch2 unit currently being operated.
3
Setting for the unit connected to TZTL12F_FB_LEFT*, controlled by MCU1.
4
Set the cycling order of units controlled by MCU1. To skip a unit, select it to [Off].
5
Setting for the unit connected to TZTL12F_MB_LEFT*, controlled by MCU2.
6
Set the cycling order of units controlled by MCU2. To skip a unit, select it to [Off].
*: For configurations with an MCU-005 connected, the nickname for the MCU-005
appears.
Example remote configuration - MCU-004
Description
1. SYSTEM INTRODUCTION
1-9
Advertisement
Table of Contents
