How To Follow A Route; How To Follow An On-Screen Route - Furuno NAVnet TZtouch2 Operator's Manual

5. ROUTES
5.10

How to Follow a Route

Before you follow a route, make sure that the path to the route is clear. Make sure to
zoom your chart to check for hazards that do not appear on a smaller scale.
5.10.1

How to follow an on-screen route

1. Tap a route leg of the route to follow to show the pop-up menu.
2. Tap [Start Nav].
Arrow points in direction to follow route
Boat icon
(current position)
The following occurs:
• The line for the selected route turns red.
• The go to point (1st route point) is highlighted.
• A thick red dashed line and a yellow line run between the current position and the
1st route point of the selected route. The thick red dashed line is the course to follow
to get to the 1st route point. The yellow line is the shortest course from the current
position to the go to point.
• The go to point is numbered "1". The starting point is indicated in the pop-up menu
item [Details] as [Start].
• The arrival area marker appears if activated on the menu (see subsection 5.11.5).
• The XTE lines, red for port side, green for starboard side, appear. You can show or
hide these lines and set their width with [Display XTE Lines] and [XTE Value] re-
spectively in [Routes] menu.
Note: If you want to be notified when you reach a go to point, turn on [Waypoint Cross-
ing Notification] on [Routes] of the menu (see subsection 5.11.8). Then the message
"Waypoint Crossing" appears when you reach a go to point. For the arrival timing, see
subsection 5.11.5.
5-10
2 2
1 1
XTE line
Green: starboard
Red: port
Course to 1st route point
(thick red dashed line)
Route leg (red line)
4 4
3 3
Arrival area (appears when
you select [Circle and
Cross Line] or [Circle] in
the [Routes] - [Waypoint
Switching Mode].)