Chart Plotter; Creating A Route - Furuno MFD8 Operator's Manual

Chart Plotter

Placing a point at cursor location
Position
cursor.
POINTS
ROUTE

Creating a route

Place cursor
on 1st point
of route.
Place remaining points.
3D display
SHIP
3D
Long push to
activate or deactive.
Point marked
on chart plotter
PT 0001
POINTS
ROUTE
Long push
+
Adjust
pitch. Confirm
setting.
Confirm
Rotate
setting.
picture.
Going to cursor position
Select
location.
GO TO
LIST
Drag cursor
Mark point.
to next point.
Tip!
If you marked a point
at the wrong position
press
Save route.
* This procedure is available when 3D/Pan Tilt
Mode in the Chart-General menu is active.
2
Cursor position
set as destination
to undo.
CANCEL