Auto Pan - Yamaha DM2000 Owner's Manual

OCTA REVERB
Eight input, eight output reverb.
Parameter Range
REV TIME 0.3–99.0 s
REV TYPE Hall, Room, Stage, Plate
INI. DLY 0.0–100.0 ms
HI. RATIO 0.1–1.0
LO. RATIO 0.1–2.4
DIFF. 0–10
DENSITY 0–100%
E/R BAL. 0–100%
HPF THRU, 21.2 Hz–8.00 kHz
LPF 50.0 Hz–16.0 kHz, THRU

AUTO PAN 5.1

Six input, six output autopanner for 5.1 surround. You can reset to the pan position specified by
the OFFSET parameter by pressing the RESET button.
Parameter Range
OFF, HOLD, INPUT1,
INPUT2, INPUT3,
SOURCE
INPUT4, INPUT5,
INPUT6, MIDI
TRIG. LVL –60 to 0 dB
TRG MASK 0–1000 ms
TIME 0.0 s–10.0 s
SPEED 0.05 Hz–40.00 Hz
DIR. Turn L, Turn R
OFFSET –180 to +180 degrees
HPF THRU, 21.2 Hz–8.00 kHz
LPF 50.0 Hz–16.0 kHz, THRU
CHORUS 5.1
Six input, six output chorus for 5.1 surround.
Parameter Range
FREQ. 0.05–40.00 Hz
AM DEPTH 0–100%
PM DEPTH 0–100%
MOD. DLY 0.0–400.0 ms
WAVE Sine, Tri
HPF THRU, 21.2 Hz–8.00 kHz
LPF 50.0 Hz–16.0 kHz, THRU
SYNC OFF/ON
1
NOTE
1.
Description
Reverb time
Reverb type
Initial delay before reverb begins
High-frequency reverb time ratio
Low-frequency reverb time ratio
Reverb diffusion (left–right reverb spread)
Reverb density
Balance of early reflections and reverb
(0% = all reverb, 100% = all early reflections)
High-pass filter cutoff frequency
Low-pass filter cutoff frequency
Description
When set to OFF, the TRIGGER button is used to start autopan.
When set to HOLD, autopan runs continuously. When set to INPUT
1–6, the specified channel's input signal triggers autopan. When set
to MIDI, a MIDI Note On message can be used to trigger autopan.
Input trigger level (i.e., the signal level required to trigger panning
when SOURCE set to INPUT)
Trigger Mask specifies the time from when a trigger is received until
the next trigger will be accepted.
The time after which autopan starts once it's been triggered
Autopan speed
Autopan direction
Pan offset
High-pass filter cutoff frequency
Low-pass filter cutoff frequency
Description
Modulation speed
Amplitude modulation depth
Pitch modulation depth
Modulation delay time
Modulation waveform
High-pass filter cutoff frequency
Low-pass filter cutoff frequency
Tempo parameter sync on/off
Used in conjunction with TEMPO to determine FREQ.
327
Effects Parameters
DM2000—Owner's Manual