Selecting Channels; Assigning Inputs To Channels - Yamaha DM2000 Owner's Manual

Selecting Channels

Channels can be selected as follows.
(Make sure the ENCODER MODE [ASSIGN 4] (INSERT) button indicator is not lit before
proceeding.)
1 Use the [SEL] buttons to select channels.
The [SEL] button indicators of selected channels light up. The border of the corresponding
channel strip displays also light up.
To select multiple channels in each eight-channel block (e.g., 1–8, 9–16, or
2
17–24), while holding down one [SEL] button, use the [SEL] buttons of the
other channels in the same block to add and remove channels.
The following shortcuts apply.
Select multiple channels
Select all channels
Inverse the channel selection

Assigning Inputs to Channels

Channels can be assigned to input sources as follows. Before starting the steps below, stop
the Pro Tools transport section.
You can view the current input source assignment for each channel on the channel strip dis-
plays by pressing and holding the ENCODER MODE [ASSIGN 1] (INPUT) button.
Press the ENCODER MODE [ASSIGN 3] (SEND ASSIGN) button.
1
Its button indicator flashes, and the SELECT ASSIGN section of the display shows "ASGN."
Press the ENCODER MODE [ASSIGN 1] (INPUT) button.
2
Its button indicator lights up, and the channel strip displays show the current input source
for each channel.
Use the Encoders to select input sources.
3
The names of the input sources appear on the channel strip displays in abbreviated form.
When you select a source other than the current, the ring of the corresponding channel strip
display flashes.
4 To confirm your selection, press the Encoder's push-switch.
The channel strip display ring stops flashing.
The following shortcuts apply.
Set all channels to the same input
source
Set all selected channels to the same
input source
You can cancel this function by pressing the [–/DEC] (ESC) button.
To do this...
USER DEFINED KEYS [4] + [SEL]
USER DEFINED KEYS [5] + [SEL]
USER DEFINED KEYS [13] + [SEL]
To do this...
ENCODER MODE [ASSIGN 3], ENCODER MODE [ASSIGN 1],
Encoder, USER DEFINED KEYS [5] + Encoder push-switch
ENCODER MODE [ASSIGN 3], ENCODER MODE [ASSIGN 1],
Encoder, USER DEFINED KEYS [5] + USER DEFINED KEYS [4] +
Encoder push-switch
Selecting Channels
Do this!
Do this!
DM2000 Version 2—Owner's Manual
239