Yamaha DM2000 Owner's Manual page 210

210
Chapter 17—Automix
The SOURCE section enables you to select the copy source Automix. You can select CUR-
RENT (the current Automix) or MEM (any Automix from 1 to 16).
The TIME parameter determines the point to which the specified data is copied. The num-
ber in parentheses on the right indicates the end point of the copy destination. You can set
the TIME parameter on-the-fly by selecting the TIME button, then pressing [ENTER]. You
can edit the captured timecode value using the Parameter wheel or INC/DEC buttons. Press
[ENTER] to reset the currently-selected digit to "00."
The CH parameter specifies the channel to which the specified data will be copied. The
number of destination channels depends on the specified number of copy source channels.
For example, if Input Channels 1 though 8 are specified as the source, then the number of
destination channels will be eight (8). Destination channels are contiguous and only the
first channel in the range can be specified. The number in parentheses on the right indicates
the last channel in the copy destination.
You cannot copy from Input Channels to Output Channels. Also, even within Output
Channels, you cannot copy between Aux and Bus channels.
TRIM: The TRIM button trims the specified Automix data. This Job includes a TRIM
EDIT section below the TIME SETTING section.
The IN parameter determines the amount of time required for the faders to achieve the
specified trim amount. The OUT parameter determines the amount of time required for
the faders to return to the previous levels. The LEVEL parameter specifies the fader trim
amount in the range of –96 dB to +96 dB.
MOVE/MERGE: This Job features a SOURCE section and a MOVE TO (MERGE TO)
section below the TIME SETTING section. The function of this button changes depending
on the SOURCE section setting. If you select CURRENT (current Automix) in the
SOURCE section, this button becomes the MOVE button, which enables you to move the
specified range of Automix data to another position. If you select MEM (Automix memo-
ries 1–16) in the SOURCE section, this button becomes the MERGE button, which enables
you to merge the specified range of Automix data with other Automix data.
The SOURCE section enables you to select the move/merge source Automix. You can select
CURRENT (the current Automix) or MEM (any Automix from 1 to 16).
DM2000 Version 2—Owner's Manual
Existing data
Trim: – x dB
Trimmed data
TRIM IN
IN
TRIM OUT Time
OUT