Assigning Send Destinations; Configuring Sends As Pre Or Post - Yamaha DM2000 Owner's Manual

242
Chapter 19—Pro Tools Remote Layer

Assigning Send Destinations

Sends can be assigned to output destinations as follows. Before starting the steps below, stop
the Pro Tools transport section.
You can view the current output destination assignment for each send on the channel strip
displays by pressing and holding the AUX SELECT [AUX 1]–[AUX 5] (SEND A–E) buttons.
Press the ENCODER MODE [ASSIGN 3] (SEND ASSIGN) button.
1
Its indicator flashes, and the SELECT ASSIGN section of the display shows "ASGN."
Use the AUX SELECT [AUX 1]–[AUX 5] (SEND A–E) buttons to select the
2
sends.
The button indicator of the selected send lights up, and the channel strip displays show the
current send destinations of all channels. If the currently selected send is not assigned to a
channel, "—" is displayed.
3 Use the Encoders to select send destinations.
The names of the send destinations appear on the channel strip displays in abbreviated
form. When you select a different destination, the ring of the corresponding channel strip
display flashes. When a stereo send destination is selected, its name flashes and continues to
flash even after its been confirmed.
To confirm your selection, press the Encoder's push-switch.
4
The channel strip display ring stops flashing.
The following shortcuts apply.
Set all channels to the same send des-
tination
Set all selected channels to the same
send destination
You can cancel this function by pressing the [–/DEC] (ESC) button.
Configuring Sends as Pre or Post
Sends can be configured as either pre or post as follows.
(Make sure the MATRIX SELECT [MATRIX 2] (SEND MUTE) button indicator is not lit
before proceeding.)
Use the AUX SELECT [AUX 1]–[AUX 5] (SEND A–E) buttons to select the
1
sends.
The ENCODER MODE [AUX/MTRX] (SEND LEVEL) button indicator lights up, as does
the button indicator of the selected send.
2 Use the Encoder push-switches to toggle between pre and post.
DM2000 Version 2—Owner's Manual
To do this...
ENCODER MODE [ASSIGN 3], AUX SELECT [AUX 1]–[AUX 5],
Encoder, USER DEFINED KEYS [5] + Encoder push-switch
ENCODER MODE [ASSIGN 3], AUX SELECT [AUX 1]–[AUX 5],
Encoder, USER DEFINED KEYS [5] + USER DEFINED KEYS [4] +
Encoder push-switch
Do this!