Installing Driveline And Shielding On An R116 - Small Driven Drums - MacDon R1 Series Installation Instructions Manual

3.11.2 Installing Driveline and Shielding on an R116 – Small Driven Drums
To reinstall the vertical driveline and shielding on an R116, follow these steps:
If you are working on an R113, refer to
NOTE:
3.3.2 Removing Driveline on an R116 – Small Driven Drums, page
Use parts retained from
1. Lubricate spindle splines (A). For specifications, refer to the
header technical manual.
NOTE:
For clarity, illustration shows a cutaway view of drum and
tube shield.
2. Insert driveline (B) at an angle and guide it past hub
drive (C) and drum (D).
3. Insert splined spindle end (A) into splined bore of
driveline (B).
4. Place a bead of medium-strength threadlocker
®
(Loctite 243 or equivalent) around the threads of four
M12 hex flange head bolts (A). Use the bolts and spacers to
secure driveline assembly (B) to hub drive (C). Torque bolts
to 102 Nm (75 lbf·ft).
5. Position two drum shields (B) as shown. Apply a bead of
medium-strength threadlocker (Loctite
around the threads of eight M8 hex flange head bolts (A).
Use the bolts to secure the drum shields in place. Torque
hardware to 27 Nm (20 lbf·ft).
214497
INSTALLATION INSTRUCTIONS
3.11.1 Installing Driveline and Shielding on an R113 – Large Driven Drums, page
®
243 or equivalent)
33
14.
D
Figure 3.58: Driveline
A
Figure 3.59: Driveline
Figure 3.60: Driven Drum
30.
C
B
A
C
A
B
B B
A
Revision D