Removing Outboard Rock Guards - MacDon R1 Series Installation Instructions Manual

3.8 Removing Outboard Rock Guards

WARNING
Exercise caution when working around the blades. Blades are sharp and can cause serious injury. Wear gloves when
handling blades.
Before installing the cutterbar, remove the outboard rock guards as follows to simplify installation.
1. Locate rock guard (B) on the bottom outboard end of the
cutterbar. There is one guard on each end of the cutterbar.
2. Remove the two hex head screws (A), washers, and lock
nuts (C) securing rock guard (B) to the cutterbar assembly.
3. Remove bolt and washers (A).
4. Loosen bolt (B).
5. Remove rock guard (C) by sliding it forward.
6. Repeat Steps 1, page 21
of the cutterbar.
214497
INSTALLATION INSTRUCTIONS
to 5, page 21 at the opposite side
B
Figure 3.31: Left Outboard Rock Guard – View
from Rear
C
Figure 3.32: Left Outboard Rock Guard – Side View
21
C
A
A
B
Revision D