Removing Drivelines - MacDon R1 Series Installation Instructions Manual

3.3 Removing Drivelines

DANGER
To avoid bodily injury or death from unexpected start-up or fall of a raised machine, stop engine, remove key, and
engage windrower lift cylinder safety props (headers) or lift cylinder lock-out valves (pull-types) before going under
machine for any reason.
1. Raise the header/pull-type fully and then engage the safety
props (headers) or the lift cylinder lock-out valves (pull-
types) to prevent an unexpected fall before going under the
machine.
2. Headers: Pull lever (A) rotate toward header to release, and
lower the safety prop onto the cylinder. Repeat on
opposite side.
IMPORTANT:
Ensure the safety props engage over cylinder piston rods. If
safety prop does not engage properly, raise the header until
the safety prop fits over the rod.
3. Pull-type: Close the lock-out valve (A) on each lift cylinder
by turning the handle to the closed position (90° angle to
the hose).
214497
INSTALLATION INSTRUCTIONS
Figure 3.7: Safety Props – Right Shown, Left Similar
Figure 3.8: Lift Cylinder Lock-out Valve
10
A
A
Revision D