Removing Driveline On An R116 - Small Driven Drums - MacDon R1 Series Installation Instructions Manual

3.3.2 Removing Driveline on an R116 – Small Driven Drums
To remove the vertical driveline from an R116 with small driven drums, follow these steps:
If you are working on an R113 or an R116 with large driven drums, refer to
Driven Drums, page 11.
NOTE:
Retain all parts for reassembly unless otherwise stated.
1. On the left side of the cutterbar, remove four M10 hex
flange head bolts (A) and remove vertical driveshield (B).
2. Remove two M10 hex flange head bolts (B) and cover
plate (A).
3. Remove four M10 hex flange head bolts (A), top plate (B),
and drum top (C).
214497
INSTALLATION INSTRUCTIONS
Figure 3.17: Driven Drum
Figure 3.18: Driveline Shield
Figure 3.19: Driveline Shield
14
3.3.1 Removing Driveline on an R113 – Large
A A A A
B
A
B
B
A
B
C
Revision D