Setting Up Your Printer In Windows 95 - Epson EPL-N2000 User Manual

7. When finished, click OK to return to the Summary dialog
box. Or, click Update to send the new settings to the
Ethernet card without closing the Config dialog box.
c
8. Click Exit to exit EPSON Net! for Windows.
After configuring the Ethernet card for TCP/IP, set up your
printer in Windows and make sure that the TCP/IP network
can work correctly.

Setting up your printer in Windows 95

After configuring the Ethernet card, you need to set up the
network printer on each computer. In Windows 95, use the
Add Printer wizard as follows:
Note:
Before setting up your printer in Windows 95, you must install the
EPSON Status Monitor. For installation instructions, see Chapter 7.
1. Open the Printers folder.
2. Double-click Add Printer.
3. Click Network Printer and click Next.
4. Click Browse; then double-click the EPSON Printer Network
icon. If you do not see the EPSON Status Monitor, it has not
been installed. See Chapter 7 for installation instructions.
5. Double-click the domain icon that the printer is connected to.
6. Select your printer icon; then click OK.
Caution:
Once you make changes to the Ethernet card, you must wait
for at least five minutes before turning off or rebooting your
printer.
Using Windows
3-21