Epson EPL-N2000 User Manual page 79

Configuring the Ethernet card as a remote printer
After setting up the NetWare print server, follow these steps to
configure the Ethernet card in Remote Printer mode:
1. Start EPSON! Net for Macintosh.
2. Highlight the printer you want to configure from the list.
3. Click Open in the Summary dialog box.
4. Click the NetWare icon. Make sure the correct serial number
of the target Ethernet card is shown.
Note:
Press the status sheet button on the Ethernet card plate to
confirm the serial number for the printer in question. If a different
serial number is shown on the status sheet, click Cancel to
return to the Summary dialog box and select the correct one.
5. Click Remote Printer.
6. Type the printer server name in the Print Server name box. It
must be the same as the one you have set up for NetWare.
7. Type the port number in the Port number box. It must be the
same as the one you have set up for the NetWare print
server and print queue.
8. Click OK to return to the Summary dialog box. When you
click Update, only the new settings are sent to the Ethernet
card without closing the Config dialog box.
c
Caution:
Once you make changes to the Ethernet card, you must wait
for at least five minutes before turning off or rebooting your
printer.
Using Macintosh
4-13