Configuring The Ethernet Card - Epson EPL-N2000 User Manual

Configuring the Ethernet card

To use TCP/IP on the network, you can set the IP address for
the Ethernet card using EPSON Net! for Windows. Follow
these steps in Windows NT:
1. Start EPSON! Net for Windows.
2. Click TCP/IP in the Protocol dialog box.
Note:
EPSON Net! for Windows cannot use TCP/IP in Windows 3.1.
However to configure the card for TCP/IP, click NetWare , if it
is available, and click Open . Then skip to step 5.
3. Highlight the printer you want to configure from the list.
Note:
If you have connected more than one printer with the same type of
Ethernet card to the network, you can distinguish which card is
which using the card's unique serial numbers. Press the status
sheet button on the Ethernet card plate to print a status sheet for
each printer and check the serial numbers.
4. Click Open.
Using Windows
3-19