Using Dos - Epson EPL-N2000 User Manual

Chapter 2

Using DOS

This chapter describes how to configure the Ethernet card with
EPSON Net! for NetWare DOS to operate with Novell
NetWare. If you use DOS as your operating system, you need
to use this utility program to configure the card.
Before configuring the Ethernet card, make sure of the
following points:
Has Novell NetWare been set up to provide print services
on the network? For details about setup, see your Novell
NetWare documentation.
Will you use the card as a dedicated print server, remote
printer, or mix of these two modes using the Ethernet
card's Auto Print Server/Remote Printer mode? See the
appropriate section in this chapter for more information.
Has the printer been set up with the Ethernet card
connected to the network, and has it been turned on? For
details, see Chapter 1 in this manual and your printer
user's guide.
2-1
Using DOS
2