Throttle Acceleration "Accel - RadioLink RC6GS V2 Instruction Manual

When steering mixing is set and steering operation enters the set range, "*" is displayed in front of the number.
When mixing is OFF, the A.B.S function can operate over the entire steering range.
When ending setting, return to the initial screen by pressing "Exit" button twice.

2.10 Throttle Acceleration "ACCEL"

Function which adjusts the movement characteristic from the throttle neutral position.
The servo will jump to the input position at its maximum possible speed. Unlike exponential, which adjusts the
whole throttle movement into a curve, throttle acceleration simply "jumps" away from neutral and then leaves
the remaining response linear.
Setup item
FWRD: Forward side acceleration amount
BRAK: Brake side acceleration amount
Throttle acceleration adjustment
Enter the function menu and use "Dec(-)" or "Inc(+)" button to access
ACCEL function, then press "Enter" button to get into ACCEL function
interface.
(1) Forward acceleration amount adjustment
Press "Dec(-)" or "Inc(+)" button to select "FWRD", press"Enter"key to
confirm and the initial value of "FWRD" will blink, then use "Dec(-)"or"Inc(+)" button adjust the acceleration
amount.
(Note: In the interface of adjusting the value, return to the initial value "0%" by pressing "Dec(-)" and "Inc(+)"
buttons simultaneously for about 1 second.)
Press"Enter"button, the adjusted value stops blinking, now the value has been set.
"0%": No acceleration
"100%": Maximum acceleration(Approximately1/2of the forward side steering angle)
Forward acceleration amount(FWRD)
0%~100%
Initial value: 0%
(2) Brake side acceleration amount adjustment
Press "Dec(-)" or "Inc(+)" button to select " BRAK ", press"Enter"key to confirm and
Steering mixing (STM)
OFF, N10 ~ N100, E10 ~ E100
Initial value: OFF
15
RadioLink Electronic Ltd
www.radiolink.com