Steering Exponential "Stexp - RadioLink RC6GS V2 Instruction Manual

Digital 6-channel proportional rc system, adaptable to rc cars/boats/robot
Hide thumbs Also See for RC6GS V2:
Table of Contents

Advertisement

amount adjustment, and channel 3 servo up side/down side operation amount adjustment during linkage.
Correct the maximum steering angle and left and right steering angles when there is a difference in the
turning radius due to the characteristics, etc. of the vehicle.
Setting item (channel and directio
Steering EPA
ST:0%~120%(left/ right)
Initial value:100%
Aux Servo EPA
CH3:0%~120%(left/ right)
Initial value: 100%
Aux Servo EPA
CH5:0%~120%(left/ right)
Initial value: 100%
End point adjustment
(1) Access the function menu (By pressing "Exit" and "Enter" buttons
simultaneously and holding them down for one second),press "Inc(+)"
button twice to chose EAP function.
(2) Press "Enter" button to get into EPA function interface, use "Dec(-)"
or "Inc(+)" button to select the desired setting item , press "Enter" key,
the initial value of your selected setting item will blink, then you can
press "Dec(-)" or "Inc(+)" button to adjust the value of your selected setting item.
(Note: In the interface of adjusting the value, return to the initial value "100%" by pressing "Dec(-)" and "Inc(+)"
buttons simultaneously for about 1 second.)
3. Press "Enter" button, the adjusted value of your selected setting item stops blinking, now the value of your
selected setting item has been set.
4. Return to the initial screen by pressing "Exit" button twice.

2.5 Steering Exponential "STEXP"

This function is used to change the sensitivity of the steering
servo around the neutral and both ends position. It has no effect
on the maximum servo travel.
Adjust the sensitivity of direction wheel both in neutral position and
ends.
Setup Item
RATE: Steering EXP rate
Adjustment range
-100%~0%~+100%
Initial value: 0%
0%~-100%: Sensitivity around neutral position is low, getting higher when approaching ends.
0%: Sensitivity around the neutral and ends position is equal
Throttle EPA
TH:0%~120%(forward/brake)
Initial value : 100%
Aux Servo EPA
CH4:0%~120%(left/ right)
Initial value: 100%
Aux Servo EPA
CH6:0%~120%(left/ right)
Initial value: 100%
8
RadioLink Electronic Ltd
www.radiolink.com

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Rc4gs v2Rc6gs

Table of Contents