Throttle Speed "Thspd - RadioLink RC6GS V2 Instruction Manual

RadioLink Electronic Ltd
www.radiolink.com
Adjustment range
RATE: -100 ~ 0 ~ +100
0~-100: flat braking
0: uniform braking
0~+100: sensitive braking
Brake side adjustment (select BRK)
(1) Press "Enter" key, the current BRK value will blink, use "Inc(+)" button to adjust the + side when you want
to quicker the rise and use"Dec(-)" button to adjust the - side when you want to make the rise milder.
(Note: In the interface of adjusting the value, return to the initial value "0" by pressing "Dec(-)" and "Inc(+)"
buttons simultaneously for about 1 second.)
(2) Press "Enter" button, the adjusted BRK value stops blinking, now the BRK value has been set.
(3) When ending setting, return to the initial screen by pressing "Exit" button twice.

2.8 Throttle Speed "THSPD"

Throttle servo delay
Sudden trigger operation on a slippery road only causes the wheels to
spin and the vehicle cannot accelerate smoothly. Setting the throttle
speed function reduces wasteful battery consumption while at the same
time permitting smooth, enjoyable operation.
Operation
Throttle servo(amp )operation is delayed so that the drive wheels will
not spin even if the throttle trigger is operated more than necessary.
This delay function is not performed when the throttle trigger is returned
and at brake operation.
OFF: Speed1 or speed2 can be selected.
OFF means shut down the throttle speed function
Adjustment method for SPEED1
Setup items
MODE: Speed type selection
ALL: Speed adjustment
Adjustment range
0~100 (each direction)
At 100, there is no delay
(1) Enter the function menu and use "Dec(-)"or"Inc(+) " button to access THSPD function.
(2) Press "Enter" button to get into THSPD function interface.
(3) If initial MODE setup item is SPEED1, {if initial MODE setup item is SPEED2 or OFF, you need to select
SPEED1 by pressing"Dec(-)" or "Inc(+)"button to select MODE setup item , then press "Enter" key, SPEED2
or OFF will blink, press "Dec(-)" or "Inc(+)" button, when the blinking SPEED 2 or OFF change to blinking
SPEED 1, press "Enter" key, SPEED1 will stop blink, now SPEED1 is selected}, press "Dec(-)" or "Inc(+)"
button to select ALL setup item, then press"Enter" key, the initial value will blink, use"Dec(-)"or"Inc(+)" button
to adjust the delay of the entire throttle forward side range.
(Note: In the interface of adjusting the value, return to the initial value "100" by pressing "Dec(-)" and "Inc(+)"
buttons simultaneously for about 1 second.)
Press "Enter" button, the adjusted value stops blinking, now the value has been set.
11