Throttle Acceleration "Accel - RadioLink RC4GS Instruction Manual

initial value of "STM" will blink. Use "Dec(-)" or "Inc(+)" button to adjust the steering mixing
range. (Note: In the interface of adjusting the value, return to the initial value "OFF" by pressing
"Dec(-)" and "Inc(+)" buttons simultaneously for about 1 second.)
Press"Enter"button, the adjusted value stops blinking, now the value has been set.
-Sets the range within which the A.B.S. function is performed relative to steering wheel operation.
When steering mixing is set and steering operation enters the set range, "*" is displayed in front of
the number. When mixing is OFF, the A.B.S function can operate over the entire steering range.
When ending setting, return to the initial screen by pressing "Exit" button twice.

4.10 Throttle Acceleration "ACCEL"

Function which adjusts the movement characteristic from the throttle neutral position.
The servo will jump to the input position at its maximum possible speed. Unlike exponential,
which adjusts the whole throttle movement into a curve, throttle acceleration simply "jumps"
away from neutral and then leaves the remaining response linear.
Setup item
FWRD: Forward side acceleration amount
BRAK: Brake side acceleration amount
Throttle acceleration adjustment
Enter the function menu and use " Dec(-) "
button to access ACCEL function, then press "Enter" button
to get into ACCEL function interface.
(1) Forward acceleration amount adjustment
Press "Dec(-)" or "Inc(+)" button to select "FWRD", press"Enter"key to confirm and the initial
value of "FWRD" will blink, then use "Dec(-)"or"Inc(+)" button adjust the acceleration amount.
(Note: In the interface of adjusting the value, return to the initial value "0%" by pressing "Dec(-)"
and "Inc(+)" buttons simultaneously for about 1 second.)
Press"Enter"button, the adjusted value stops blinking, now the value has been set.
Steering mixing (STM)
OFF, N10 ~ N100, E10 ~
E100 Initial value: OFF
or " Inc(+) "
19