Gyro Setup - RadioLink RC6GS V2 Instruction Manual

Working Mode Mode 1
Indicator Color Green
With Gyro
Channel Corresponding signal output in different channel
BAT+-
1
2
3
4
5
6
PPM/S.B
Short press
ID set once
to Mode 2
Short press
Signal Switch
ID set 3
quickly to
Mode 4

1.2.3 Gyro Setup

A. Gyro Enabled
Factory setting is gyro function OFF by default.
Short press ID SET three times with interval less than 1 second, the RED indicator flashes three times. Red
LED on/off indicates the gyro function is on/off.
B. Gyro Phase
When the gyro forward is enabled, try to turn the model car to check if the gyro is correcting the wheels.
Normally, the wheels should turn right to correct when the car is turned left while the wheels should turn left to
correct when the car is turned right. If the gyro phase is reversed, short press the binding button (ID SET)
twice in 1 second. The Red indicator flashes twice means the gyro phase setting is complete.
R7FG Working Mode
Mode 2
Red&Blue
Blue
N N
Return port of model battery voltage
PWM PWM
PWM PWM
PWM PWM
PWM PWM
PWM PWM
PWM PWM
PPM SBUS
Short press Short press ID
ID set once set once to
to Mode 1
Short press
Short press ID
ID set 3
set 3 times
times times
quickly to
Mode 3
Mode 3 Mode 4
Red&Green
(Purple) (Orange)
Y Y
PWM PWM
PWM PWM
PWM PWM
PWM PWM
PWM PWM
PWM PWM
SBUS PPM
Short press ID
set once to
Mode 4 Mode 3
Short press ID
set 3 times
quickly to quickly to Mode
Mode 2 1
4
RadioLink Electronic Ltd
www.radiolink.com
Note
/
Multicolor light indicator on
means gyro function on
/
/
Rudder
Throttle
Aux
Aux
Aux
Aux
Green is PPM, Blue is
S-BUS ，
flight controller can be
connected under SBUS/PPM
mode and achieve different
models control incl.
Mecanum
car/Robot/Engineering
Off-road cars
/
/