Function "A.b.s - RadioLink RC6GS V2 Instruction Manual

RadioLink Electronic Ltd
www.radiolink.com
(4) When ending setting, return to the initial screen by pressing "Exit" button twice.
Adjustment method for SPEED2
Setup items
MODE: Speed type selection
LOW: Low side range speed adjustment
HIGH: High side range speed adjustment
TGP1: Low and medium speed switching point
Adjustment range
LOW: 0~100
HIGH: 0~100
At 100, there is no delay
TGP1: 0~100
(1) Enter the function menu and use "Dec(-)"or "Inc(+) " button to access THSPD function.
(2) Press "Enter" button to get into THSPD function interface.
(3) If initial MODE setup item is SPEED 2,{ if initial MODE setup item is SPEED 1, you need to select
SPEED2 by pressing "Dec(-)" or "Inc(+)" button to select MODE setup item, then press "Enter" key, SPEED1
or OFF will blink, press "Dec(-)" or "Inc(+)" button, when the blinking SPEED1 or OFF change to blinking
SPEED2, press "Enter" key, SPEED2 will stop blinking, now SPEED2 is selected}, press "Dec(-)" or "Inc(+)"
button to select "LOW" or "HIGH" delay adjustment or"TGP1" speed switching point adjustment.
(4) Press "Enter" key to confirm "LOW" or "HIGH" or "TGP1" setup item, and the value of your selected
setup item will blink. Use "Dec(-)" or "Inc(+)" button to adjust the value.
(Note: In the interface of adjusting the value, return to the initial value (the initial value of LOW and HIGH is
"100", the initial value of TGP1 is "30") by pressing "Dec(-)" and "Inc(+)" buttons simultaneously for about 1
second.)
Press "Enter" button, the adjusted value stops blinking, now your selected value has been set.
(5) When ending setting, return to the initial screen by pressing "Exit" button twice.
2.9 A.B.S. Function "A.B.S"
Pulse brake
When the brakes are applied while cornering with a 4 Wheel Drive or other type of vehicle, under-steer may
occur. The generation of under-steer can be eliminated and corners can be smoothly cleared by using this
function.
Operation
- When the brakes are applied, the throttle servo will pulse
intermittently. This will have the same effect as pumping the brakes in
a full size car.
- The brake return amount, pulse cycle, and brake duty can be
adjusted.
- The region over which the ABS is effective can be set ac-cording to
the steering operation. (Mixing function)
Setup items
ABP: Brake return amount
DLY: Delay amount
CYC: Cycle speed
12