Care And Maintenance; Cleaning Instructions - Nonin Sensmart H500 Operator's Manual

Care and Maintenance

Care and Maintenance
The advanced digital circuitry within the Model H500 system components
requires no calibration or periodic maintenance.
Do not attempt to open the case of any of the system components or repair the
electronics. Opening the case will damage the component and void the
warranty. If the device or system is not functioning properly, see
"Troubleshooting" section on page 35.
Plus7
The Oxitest
used to verify operation of the pulse oximeter. The Oxitest cannot be used to
verify COHb, MetHb, or rSO
CAUTIONS:
!
• Follow local, state and national governing ordinances and
recycling instructions regarding disposal or recycling of the device
and device components, including batteries.
• Batteries are a fire hazard if damaged. Do not damage,
mishandle, disassemble, service, or replace with non-specified
components.
• Do not charge Li-Ion batteries at a temperature of 0 °C (32 °F) or
less as this may result in significantly reduced battery life.

Cleaning Instructions

The following cleaning instructions apply to the display and signal processor.
1. Wipe the component with a soft cloth dampened with a cleaning solution.
Do not use undiluted bleach or any cleaning solution other than those
listed below, as permanent damage could result.
2. Allow to air-dry.
Approved cleaning chemicals:
• Isopropyl Alcohol
The following cleaning instructions apply to the carrying case.
• Clean with a mild detergent (see note) in warm water. Allow to air dry. Do
not machine wash or dry.
NOTE: To clean washable surfaces, use in a solution of warm water and
detergent. Mild detergents, such as hand and dish-washing liquid detergents,
dissolve dirt and grease.
(software rev. 2.5 or greater) by Datrend Systems, Inc. can be
values.
2
31