Signal Processor (Sp-Ble); Figure 7. Sp-Ble Signal Processor; Table 5. Sp-Ble Features - Nonin Sensmart H500 Operator's Manual

Signal Processor (SP-BLE)

System signal processor calculates all measurements and sends to paired
display through a Bluetooth low energy (BLE) wireless connection.
Signal processor requires a SenSmart sensor to be applied to the sensor port
to take measurement. See "Connect/Disconnect a Sensor to the Signal
Processor" section on page 19 for sensor connection instructions.
4
No. Symbol
1
2 NA
3
4 NA
5
18

Figure 7. SP-BLE Signal Processor

Table 5. SP-BLE Features

On/Off Button
• On – Press and hold power button.
• Off (Long-Term Storage Mode) – For information on
putting signal processor into long-term storage mode,
see "Placing Device in Long-Term Storage Mode"
section on page 25.
Signal Processor Charging Port
Bluetooth Indicator
Bluetooth indicator LED flashes blue when signal processor is
ready for a connection to display and solid blue when a
connection has been made.
Sensor Connection Port
Signal Processor Battery Indicator
Shows the current battery status of the signal processor. For
more information on signal processor battery, see "Charging
the System" section on page 23.
System Components and Set Up
1
5
3
Description
2