Figure 8. Connect Sensor To Signal Processor - Nonin Sensmart H500 Operator's Manual

System Components and Set Up
Connect/Disconnect a Sensor to the Signal Processor
1. To connect:
a. Flip the clear lock on the signal processor back to expose the
connection port.
b. Align the arrows on the sensor connector and the signal processor
(Figure 8-A). Insert the sensor connector into the signal processor
connection port.
c. Flip the lock over the sensor connector and click it into place (Figure
8-B).
A

Figure 8. Connect Sensor to Signal Processor

2. To disconnect:
a. Flip the clear lock on the signal processor back to disengage the lock
from the connector.
b. Grasp the connector and remove it from the signal processor.
Replacing the Lock on the Signal Processor
NOTE: Replacement locks may be ordered if the lock is lost or damaged.
1. Align the lock hinge with the connector end of the signal processor
(Figure 9-A).
2. Gently spread the lock hinge so it fits over the end of the signal
processor.
B
19