Care And Maintenance; Maintenance; Cleaning The Co 2 Sensor; Returning The Co 2 Sensor For Service - Nonin 9847 Operator's Manual

Care and Maintenance

Wipe the device with a soft cloth dampened with a mild detergent or 10% bleach solution. Do not use
undiluted bleach or any cleaning solution other than those recommended here, as permanent damage
could result. Dry with a soft cloth, or allow to air dry.
Clean the device separately from the sensors. For instructions on cleaning pulse oximeter sensors, refer
to the respective sensor instructions for use.
CAUTION: Do not place the Model 9847 in liquid or clean it with agents containing
!
ammonium chloride, isopropyl alcohol, or products that are not listed in this User's
Guide.

Maintenance

The 9847 requires no routine calibration or maintenance, other than battery replacement.
CAUTION: Do not use caustic or abrasive cleaning agents on the device or the
!
sensors.
CAUTION: Do not autoclave or immerse the device or sensors in liquid. Do not
!
expose the device or components to excessive moisture or liquids.
Plus7
The Oxitest by Datrend Systems, Inc. can be used to verify operation of the pulse oximeter.
Cleaning the CO
CAUTION: Do not immerse the CO
!
abrasive cleaning agents on the CO
The CO sensor is protected against splashing water.
2
Cleaning the CO Sensor
2
Clean the Model 9840SA CO
spray any liquids onto the Model 9840SA CO
thoroughly before reusing.
Returning the CO
If the Model 9840SA CO
any contaminants, and sterilization may be required. Contact Nonin's Technical Service department for
shipping instructions.
34
Sensor
2
sensor in liquid, and do not use caustic or
2
sensor.
2
Sensor with a soft cloth dampened with isopropyl alcohol. Do not pour or
2
2
Sensor for Service
2
Sensor must be returned to Nonin for service, the product should be free of
2
Sensor. Allow the Model 9840SA CO
Care and Maintenance
Sensor to dry
2