Table of Contents
Advertisement
System Operation
Event Marking
NOTE: New patient record can be started when the event mark button is
pressed for more than 0.5 seconds. Between patients, turn the display off.
When the device is turned on, the display begins a new patient record.
After turning on the system and applying the sensor to the patient:
1.
Press the event mark button to place an event mark in the recorded data
2.
Verify the event mark on screen increased by '1'. The event marker icon
number will increment with each mark event.
Pressing the event marker icon below will place an event number in the data file:
Event
Marker Icon
and number
Charging the System
Display and signal processor must both be charged to use system.
1.
Charge the display and signal processor using the provided Nonin
chargers.
2.
Insert charger into respective display and signal processor charging
ports.
WARNING: System cannot be used while charging. Do not charge display
or signal processor while device is in use.
#SN05555554
Figure 11. Event Marking
23
Advertisement
Table of Contents
