Turning Remote Diagnosis On/Off (Remote Diagnosis Setting) - Xerox FAX System (J) Operation Manual

Section 7 Various Settings and Registration

Turning Remote Diagnosis ON/OFF (Remote Diagnosis setting)

Especially if trouble occurs in this fax in which it is necessary to call for service, it is possible for our service center computer to access the fax
directly over the telephone line and check its status and other information about the trouble.
* To use Remote Diagnosis, it is necessary to enter into a contract with an authorized service center in advance and also to register a
predetermined Remote Test ID in advance. (Refer to "Registering the Remote Test ID (Remote Test ID setting)" on page 7-15.) For further
information, contact your service representative, an authorized service center or the place of purchase.
* If you want to cancel the procedure part way through, press the Reset key. The touch panel will return to the initial mode settings.
1
Press the Default key. The Default Setting screen will
appear.
2
Press the "Fax default" key.
(inch)
(metric)
3
Press the " " cursor key until "Remote Diag." ["Remote
diagn."] is highlighted.
4
Press the "Change #" key.
7-14
5
Select whether you want to turn Remote Diagnosis ON or
OFF by pressing either the "On" or "Off" key, as
appropriate.
(inch)
(metric)
6
Press the "Close" key. If you are finished making settings,
press the Reset key to return to the initial mode.