Related Manuals for Landoll F-847-0316
Summary of Contents for Landoll F-847-0316
- Page 1 Walking Tandem Instruction Kit LANDOLL CORPORATION 1900 North Street Marysville, Kansas 66508 (785) 562-5381 800-428-5655 ~ WWW.LANDOLL.COM F-847-0316 03/2016...
- Page 2 Walking Tandem Instructions Walking Beam Disassembly CAUTION 1. Loosen lug nuts on tires and remove both inner and Use care in removing the bushing to not damage outer tire and wheel assemblies from the walking the inner bore of the walker as the new bushing tandem.
- Page 3 WALKING TANDEM INSTRUCTIONS Figure 1-1: Walking Beam Disassembly F-847-0316 Edition...
- Page 4 WALKING TANDEM INSTRUCTIONS Bushing and Set Screw CAUTION Installation Due to the seal being on the outer edge, the 7. Install set screws to verify they go completely through bushing cannot be forced very hard or damage the hole and can contact the bushing. will occur to the seal.
- Page 5 WALKING TANDEM INSTRUCTIONS Figure 1-2: New Walking Beam Assembly F-847-0316 Edition...
- Page 6 WALKING TANDEM INSTRUCTIONS Walking Beam Reassembly 14. By putting the cross pin into the pivot pin it allows more leverage to turn the pin and push to get it 11. Using new pivot pin, apply a light coat of grease to started.
- Page 7 WALKING TANDEM INSTRUCTIONS Figure 1-3: Walking Beam Reassembly F-847-0316 Edition...
- Page 8 Equipment from Landoll Corporation is built to exacting standards ensured by ISO 9001 registration at all Landoll manufacturing facilities. Walking Tandem Instruction Kit Re-Order Part Number F-847-0316 LANDOLL CORPORATION 1900 North Street Marysville, Kansas 66508 (785) 562-5381 800-428-5655 ~ WWW.LANDOLL.COM Copyright 2014.