Table of Contents
Advertisement
Field Installation Agitator Box
The deflector on the front box must be reversed prior to
installing the Agitator Box.
1. Remove existing Seedbox Drive Chain and add the 4
pitch section to it. Set it aside.
2. Attach the mounting brackets to the sides of the box
using four 3/8 - 16 x 1" capscrews, lock washers and
hex nuts. See Figure 3-9.
3. Slide Rear Box 12 GA Washer onto the Cotter Pin
end of the Seed Shaft. If washer keeps falling off the
shaft, you may need to remove the cotter pin and
re-insert it after you have the box mounted to the
frame.
4. Position the box onto the frame and secure with four
1/2 - 13 x 1 1/4" capscrews, lock washers and hex
nuts.
5. Install chain. See Figure 3-10.
6. Remove Wing Nut and Flat Washer from Shifter
Plate. Insert Shifter Pin into Seed Box Slide and
attach to Shifter Plate with 1/2-13 x 1" Capscrew and
Flat Washer. Re-install Wing Nut and Flat Washer.
7. Attach the Seedbox Cover, using six 1/4 - 20 x 1/2"
capscrews.
8. Slip each Cover Lock Pivot into each Cover Bracket
so the ears protrude out of both sides of the bracket.
9. Apply Seed Chart and Warning Decal to Seedbox
Cover.
Remove the four 5/16-18 x 3/4" capscrews, lock washers
and hex nuts and reverse the deflector so that the upper
flare edge faces rearward instead of forward. Re-insert
the removed hardware with the head of the bolts to the
inside. See Figure 3-8.
Figure 3-8: Deflector
10. Apply Red Reflective Decal, Red-Orange Decal,
Food Plot Decal and Brillion Decal to the Rear of the
Seedbox.
ASSEMBLY
3-7
Advertisement
Table of Contents
