Field Installation Of Meter Box - Landoll Brillion FPS-6 Operator's Manual

Field Installation of Meter Box

Remove existing Seedbox Drive Chain which is no longer
needed.
1. Attach the mounting brackets to the sides of the box
using four 3/8 - 16 x 1" capscrews, lock washers and
hex nuts. See Figure 3-7.
2. Slide Sprocket Hub onto smooth end of Seed Shaft.
3. Position the box onto the frame and secure to the
frame with four 1/2 - 13 x 1-1/4" capscrews, lock
washers and hex nuts.
4. Secure Sprocket and Hub Assembly with 5/8-11 hex
nut and lock washer.
5. Turn 5/8-11 hex nut onto Seed Shaft Extension as far
as you can.
6. Apply Seed Rate Number Decal to Seed Shaft
Extension on every other flat surface of the Hex by
aligning the #8 end of the Decal with the edge of the
Hex on the thread end.
7. Slide seed shaft so that the cups are completely
closed. Turn Seed Shaft Extension onto threaded
end of seed shaft until the distance between the hex
end of the shaft and the Feed Roll measures
1-13/32". Install set screws. See Figure 3-6.
Figure 3-6: Seed Shaft Extension
8. Install Bearing on to Frame Side Plate with 1/4-20 x
1" flange head capscrew, lock washer, and hex nut.
Note that an additional Hex Nut is between the
Frame Side Plate and Bearing Flangette.
9. Turn 5/8-11 hex nut onto Seed Shaft Extension.
10. Take 56 Pitch Chain and add the 4 pitch section to it.
Install Chain. See Figure 3-10.
11. Attach Indicator Bracket to the front 1/2-13 x 1-1/4
Capscrew already used for mounting Seedbox to
Frame. Secure with lock washer and hex nut.
12. Install Indicator Pointer onto Bracket with 3/8-16 x 1"
capscrew, lock washer and hex nut.
Refer to Operation Seed Rate Section in this manual for
proper setting of seed rate.
13. Install cover with six 1/4-20 x 1/2" capscrews.
14. Slip each Cover Lock Pivot into each Cover Bracket
so the ears protrude out of both sides of the bracket.
15. Apply Seed Chart and Warning Decal to Seedbox
Cover.
16. Apply Amber Reflective Decal, Caution Decal and
Brillion Decal to the Front of the Seedbox. See
Figure 3-7.
ASSEMBLY
3-5