Adjusting The Angle Of The Elevating Footrest Avantgarde Vr /Xxl 2; Swinging Away The Elevating Avantgarde Fl Footrest (Fig. 74); Adjusting The Brake Force - Drum Brake (Fig. 75) - Otto Bock Avantgarde T Instructions For Use Manual

Adjustment/assembly instructions
6.7.6 Adjusting the angle of the elevating footrest Avantgarde VR /XXL 2 (Fig. 73)
The legrest can be adjusted within the range from 15° to 90°.
Pull the footrest upward until it has reached the desired position. The legrest automatically locks
in place.
To reposition the legrest, relieve the load on the footrest and press the release lever (Fig. 73,
item A) downward to lower the legrest. Bring the legrest to the desired position.
Make sure to always secure the legrest with your hand against uncontrolled falling
InfORMATIOn
downward when lowering it.
A
72 73

6.7.7 Swinging away the elevating Avantgarde fL footrest (Fig. 74)

Slightly lift the legrest and swing it to the inside or outside (Fig. 74).
74
6.8 Adjusting the brake force – drum brake (Fig. 75)
The brake force is adjusted at the adjustment screw (Fig. 75, item A) to achieve optimal brak-
ing effect. The brake force is increased by turning the screw counter-clockwise and decreased
by turning the screw clockwise.
Loosen the counter nut (Fig. 75, item B) and turn the adjustment screw anti-clockwise until a
frictional noise occurs at the wheel. Then tighten the adjustment screw until the frictional noise
disappears. The wheel should run freely.
90 | Ottobock Avantgarde T, Ti8�9, TiUltra, VR, XXL 2