Table of Contents
Advertisement
Dataflower
Slave Mode
In this menu you can set the device as a slave device in master/slave control mode.
01) Press the UP/DOWN buttons to select one of the following 2 options:
02) Press the ENTER button to confirm the selection.
Note:
Make sure that all slave devices in one master/slave setup are set to the same slave line,
otherwise they will not operate as the master device. Select either Slave 1 or Slave 2 for all
slave devices in the same master/slave setup.
Master Mode
In this menu you can set the device as a master device in master/slave control mode.
01) Press the UP/DOWN buttons to select one of the following 2 options:
02) Press the ENTER button to confirm the selection.
Show Mode
In this menu you can play the built-in programs.
01) Press the UP/DOWN buttons to select one of the following options:
●
Show 0:
●
Show 1 – Show 8:
02) Press the ENTER button to confirm the selection and to enable the speed adjustment.
03) Press the UP/DOWN buttons to set the speed of the selected built-in program. The adjustment range
is 00–99, from slow to fast.
04) Press the ENTER button to set the speed.
Product code: 43168
Slave 1:
Slave 2:
On:
Off:
SH-0
Select one of the 8 built-in programs
The device will operate as a slave device in
master/slave mode on line 1
The device will operate as a slave device in
master/slave mode on line 2
The device will operate as a master device in
master/slave mode
The device will not operate as a master device
in master/slave mode
All 8 built-in programs will be played randomly
24
Advertisement
Table of Contents
