Auto Run Programs; Dmx Mode; Slave Mode; Sound Control Mode - SHOWTEC Cyclone 4 Manual

1. Auto Run Programs

1) Press the MODE button on the device, until the display shows
2) With this menu you can set the Auto Mode of the Cyclone.
3) Press Setup to enter the AUTO Menu. You can choose 2 different sub
4) Use the SETUP button to scroll through the menu.

2. DMX Mode

When a DMX signal is present, the d will blink.
With this menu you can set the DMX address.
1) Press the MODE button on the device, until the display shows
2) You can choose 512 different DMX addresses.
Use the Up / Down buttons to select the required address from
3) You can also press the SETUP button to set the DMX Mode.
4 Channels

3. Slave Mode

When the display shows:

4. Sound control Mode

1) Press the MODE button on the device, until the display shows
Cyclone will react to the beat of the music.
You can adjust the sensitivity by turning the audio sensitivity on the back of the device.

5. LED Display Mode

With this menu you can set the LED Display On or Off.
1) Press the MODE button on the device, until the display shows
2) Press Setup to enter the LED Display Menu. You can choose 2 different settings.
3) Use the Up / Down buttons to select:
ON: The LED display will light all the time.
OFF: The LED display will turn off after 30 seconds.

6. Display Reverse

With this menu you can reverse the LED Display.
1) Press the MODE button on the device, until the display shows
2) Press Setup to enter the Display Reverse Menu and change the display to upside-down.
LED display regular.
LED display upside-down.

7. Version Number

With this menu you can view the version number of your Cyclone.
1) Press the MODE button on the device, until the display shows
2) Press Setup to show the version number.
Version V1.0
Speed from 01-99 and FL
Flash Frequency from 00-99
, the device is a slave device. It will now react the same as its master.
12
.
menus.
.
. Turn on the music and the
.
.
.
.