Save the carton and all packing materials. In the event that a fixture must be returned to the factory, it is important that the fixture be returned in the original factory box and packing. Your shipment includes: ● Showtec Single DP-1 with a power cable (1,25 m) ● User manual Safety Instructions Every person involved with the installation, operation and maintenance of this device has to: ●...
For replacement use fuses of same type and rating only. ● The user is responsible for correct positioning and operating of the Single DP-1. The manufacturer will not accept liability for damages caused by the misuse or incorrect installation of this device.
Single DP-1 Return Procedure Returned merchandise must be sent prepaid and in the original packing, call tags will not be issued. Package must be clearly labeled with a Return Authorization Number (RMA number). Products returned without an RMA number will be refused. Highlite will not accept the returned goods or any responsibility.
Single DP-1 Description of the device Features The Showtec Single DP-1 is a 1-channel DMX dimmer/switch. It is possible to mount the Single DP-1 to any wall, truss or a fixture which makes it suitable for any location. ● Input voltage: 230V AC, 50Hz ●...
Single DP-1 Installation Remove all packing materials from the Single DP-1. Check if all foam and plastic padding is removed. Connect all cables. Do not supply power before the whole system is set up and connected properly. Always disconnect from electric mains power supply before cleaning or servicing.
If not, the problem may be: ● The XLR cable from the controller is not connected with the input of the Single DP-1. ● The controller is switched off or defective, the cable or connector is detective, or the signal wires are swapped in the input connector.
Single DP-1 Menu Overview Main Menu Options 1. DMX Addressing 2. Dimmer/Switch 3. Dimmer Limit 4. Dimmer Preset 1. DMX Addressing 01) Press the MENU button until the display shows 02) Press the UP/DOWN buttons to choose the desired DMX address.
03) If both appear to be O.K., plug the unit in again. 04) If you are unable to determine the cause of the problem, do not open the Single DP-1, as this may damage the unit and the warranty will become void.
Single DP-1 Product Specification Model: Showtec Single DP-1 Input voltage: 230V AC, 50Hz Fuse: F10L/250V Dimensions: 100 x 80 x 195mm (LxWxH) Weight: 1,4 kg Operation Signal input: 3-pin DMX IN Signal output: 3-pin DMX OUT Output: 10A Schuko Electro-mechanical effects Housing: Metal &...