Table of Contents
Advertisement
2.
Installation
2.1
Unpacking and Inspection
2.1.1
Removing From Packaging
A typical PG9000 system includes the PG9000 Platform (see Section 2.1.1.1), a mass set (see
Section 2.1.1.6), at least one piston-cylinder assembly (see Section 2.1.1.2) and other
accessories such as vacuum reference hardware (see Section 2.1.1.3), an automated mass
handler (see Section 2.1.1.4) and/or pressure generation and control components (see the
accessory Operation and Maintenance Manual or instruction sheet).
2.1.1.1
The PG9000 Platform consists of the PG9000 Base, Remote Electronics Module,
Terminal and interconnect accessories. The Base is shipped in a custom wooden
crate. The Platform components are shipped in a reusable, molded shipping and
storage case. The cables and accessories are shipped in a corrugated container
with other PG9000 accessories including operating instructions and calibration
reports.
Open the PG9000 Base shipping crate (71 cm x 71 cm x 56 cm).
Carefully lift the PG9000 Base from its position in the lower packing insert.
Open the PG9000 components molded, reusable recalibration transit case
Remove the PG Terminal, Remote Electronics Module and Temperature-
Reinstall the packing inserts into the shipping and storage cases and store in
Platform
Note the orientation so that the same orientation will be used when PG9000
is repacked.
The PG9000 Base has a mass of 34 kg (74 lb).
recommended to remove it from the packaging with two people
on opposite sides of the shipping container.
lifting with only one person may lead to injury.
and the accessories corrugated shipping container.
Humidity Probe from the recalibration transit case and the Platform
accessories from the shipping container.
accessories (see Section 2.1.2.1).
a safe place.
Page 9
Warning
Inspect and inventory the
It is
Removing or
© 2011 Fluke Calibration
Advertisement
Table of Contents
