Emission Testing; Low Voltage Directive (Safety); Authorized Service Centers; Figure 1 Clamp-On Ferrite Installation - Fluke Hart Scientific 914 Series User Manual

we recommend that the clamp-on ferrites provided be used on the cables of probes attached
to the readout, especially if the product is used near sources of EM interference such as heavy
industrial equipment.
To attach a ferrite to a probe cable, make a loop in the cable near the connector and clamp the
ferrite around half of the loop as shown in the diagram. The ferrite can be easily snapped open
and moved to a new probe when needed.
connector

Figure 1 Clamp-on ferrite installation

1.5.3

Emission Testing

The instrument fulfills the limit requirements for Class A equipment. The instrument was not
designed to be used in domestic establishments.
1.5.4

Low Voltage Directive (Safety)

In order to comply with the European Low Voltage Directive (2006/95/EC), Hart Scientific
equipment has been designed to meet the EN 61010-1 and the EN 61010-2-010 standards.
1.6

Authorized Service Centers

Please contact one of the following Authorized Service Centers to coordinate service on your
Hart product:
Shop for Fluke products online at:
clamp-on ferrite
MyFlukeStore
www.
Before You Start
Authorized Service Centers
probe
1.888.610.7664
.com
9