Battery Installation, Life, And Status - Fluke FindFiber Source Instruction Sheet

To avoid damaging fiber connectors, to avoid data
loss, and to ensure maximum accuracy of test results:
•
Use proper cleaning procedures to clean all fiber
connectors before every use. Neglecting this step
or using improper procedures can cause
unreliable test results and may permanently
damage the connectors.
•
Cover all connectors with protective caps when
not in use.
•
Never connect the source to an active network.
Doing so can disrupt network operations.

Battery Installation, Life, and Status

Note: Fluke Networks recommends alkaline batteries.
•
The batteries last for about 80 hours of typical use.
•
Replace the batteries if the LED blinks.
•
To conserve battery power, the source turns off after 30
minutes if no keys are pressed.
W
Caution
AA
IEC LR6
NEDA 15A
ffu02.eps