Fluke PG9000 Series Operation And Maintenance Manual page 2

To prevent possible electrical shock, fire, or personal injury:
•
Read all safety Information before you use the product.
•
Use the product only as specified, or the protection supplied by the
product can be compromised.
•
High-pressure liquids and gases are potentially hazardous. Energy stored
in these liquids and gases can be released unexpectedly and with extreme
force. High-pressure systems should be assembled and operated only by
personnel who have been instructed in proper safety practices.
•
Use only the main power cord and connector approved for the voltage and
plug configuration in your country and rated for the product.
•
Make sure the ground conductor in the main power cord is connected to a
protective earth ground. Disruption of the protective earth could put
voltage on the chassis that could cause death.
•
Replace the main power cord if the insulation is damaged or if the
insulation shows signs of wear.
•
Do not put the product where access to the main power cord is blocked.
•
Do not use and disable the product if it is damaged.
•
Use this product indoors only.
© 1998 - 2011 Fluke Calibration All rights reserved.
Information in this document is subject to change without notice. No part of this document may be reproduced or transmitted in any
form or by any means, electronic or mechanical, for any purpose, without the express written permission of Fluke Calibration, 4765
East Beautiful Lane, Phoenix, Arizona 85044-5318 USA.
Fluke Calibration makes sincere efforts to ensure the accuracy and quality of its published materials; however, no warranty,
expressed or implied, is provided. Fluke Calibration disclaims any responsibility or liability for any direct or indirect damages
resulting from the use of the information in this manual or products described in it. Mention of any product or brand does not
constitute an endorsement by Fluke Calibration of that product or brand. This manual was originally composed in English and was
subsequently translated into other languages. The fidelity of the translation cannot be guaranteed. In case of conflict between the
English version and other language versions, the English version predominates.
Fluke Calibration, DH, DHI, PG9000, PG9602, CalTool and COMPASS are trademarks, registered and otherwise, of Fluke
Corporation.
Swagelok is a registered trademark of the Swagelok Company.
Krytox is a registered trademark of the Dupont de Nemours Company.
Products described in this manual are manufactured under international patents and one or more of the following
U.S. patents: 6,701,791, 5,142,483, 5,257,640, 5,331,838, 5,445,035. Other U.S. and international patents pending.
Document No. 3995967
110818
Printed in the USA
© 2011 Fluke Calibration
 Warning
Page ii