Http Response; Table 47: Setpoint Settings - WAGO -TO-PASS 761 Manual

102 Value Script FW 2.20 (Standard)
10.3

HTTP Response

The response to the request contains a string and, optionally, the time of the Web
portal.
The Web portal time adjusts the time of the WAGO TO-PASS
module.
The data string must contain the following text:
"Values stored" or "Values stored:YY/MM/DD,hh:mm:ss".
Date and time are optional and are required only if the time of the WAGO TO-
®
PASS telecontrol module is to be set via the Web portal.
The Web portal can also report that the data has not been accepted, or that the
indicated script version is not supported:
"Values not stored"
Starting from Firmware Version 02.33.08, setpoint settings for digital and analog
outputs and for changing the counters can be transmitted as replies.

Table 47: Setpoint settings

Variable Contents
?AO1
&AOn
&DOn
&CEn
&CRn
&CVn
Only those outputs that are available and that are configured for the Web outputs
are evaluated. A check should be made for inbound data sets to determine which
inputs have been configured as counters. There is no reply indicating whether the
counter setting and switching of the outputs has been successful. The subsequent
data transfer would have to be evaluated to determine this (e.g., by a feedback
loop to an input with additional alarm generation).
1. analog output
n. analog output (n: 2)
n. digital output (n: 1 ... 4)
n. activate counter input (n: 1 ... 4)
n. reset counter input (n: 1 ... 4)
n. change counter value (n: 1 ... 4)
WAGO-TO-PASS® 761
761-112 Telecontrol Module Compact, Web
®
Format
Normalized value (decimal
places allowed)
0 = not set, 1 = set
0 = active, 1 = inactive
1 = reset
Value[8], hexadecimal
telecontrol
Manual
Version 2.0.0