Figure 75 Millennium Ii Circuit Card; Figure 76 Controller Connections - GE Infinity M Series Installation Manual

NE-M Installation Guide
BSL Alarm Termination Board
An insulation displacement (punch down) type alarm terminal board (BSL3, 848741711) is provided with the system. For
a wire wrap type terminal board, order BSL4 (848749507) and perform the following steps:
Step
1
In the upper right hand corner of the MCR1 board, find the alarm board already installed.
2 Remove the two screws holding the board at the top.
3 Holding the board on both sides, slowly, but firmly, remove the alarm board from the P8 connector.
4 Connect the new alarm board to P8 and press down firmly, until the board is seated.
5 Secure the alarm board at the top using the two screws removed earlier.
Connect Controller Wiring – Millennium II
All connections to the controller are made through appropriate cable assemblies. The controller has been designed to
separate outputs, inputs, communication, and plant specific items onto to individual connectors.
850050111 Issue 03 August 2017

Figure 75 Millennium II Circuit Card

Action – Millennium II

Figure 76 Controller Connections

H5692448
RPM Modules
Alarm Board
MCR1 Card
55