GE Infinity M Series Installation Manual page 75

NE-M Installation Guide
Pulsar Controller Status Millennium Controller
Display Status Display
MIN Thermal Probe
Fail
BD AC DC
Minor
green green green
amber
-54.48V1 1000A
FLOAT
Display Amber
No response
BD AC DC
off off off
Display blank
Display blank
MIN Minor
Communication Fail
BD AC DC
green green green
-54.48V1 1000A
FLOAT
Display Amber
850050111 Issue 03 August 2017
Rect/
Dist.
Conv Module
LED
LEDs
Battery
Norm
amber
green
green
Fail
red
red
blink
blink
Fail
red
blink green
(one
Minor
Unit)
amber
Norm
green
green
Possible Problem(s)
Battery thermal probe failed.
Controller failure, all devices on the
communication bus reporting loss
of communication with controller.
Rectifier lost communication with
controller.
Rectifier removed from a running
system, but not uninstalled.
Possible Solution(s)
1. Ensure thermal probe is properly connected to thermal probe
cable.
2. Ensure cable is properly connected to the rear of the
Distribution Module.
3. If problem persists, replace thermal probe.
4. If problem persists, call your local field representative.
1. Check controller to ensure it is properly inserted into its slot. If
so, perform the following steps:
2. Remove the controller input power connector for 1 minute and
then reset.
3. If problem persists, replace controller with new controller
board.
4. If problem persists, call your local field representative.
1. Reset the rectifier by removing the rectifier, waiting
approximately 30 seconds, and replacing.
2. If problem persists, replace the rectifier.
3. If problem persists, call your local field representative.
Issue the Menu > Control / Operations > Uninstall Equipment
command for any rectifier that was removed.
H5692448
75