Table 6 Alarm Signals - Pulsar Plus - GE Infinity M Series Installation Manual

High capacity with horizontal distribution, 13 u system with galaxy pulsar plus controller, 22u system with galaxy millennium ii controller, initial/supplemental frame, 22u system with supplemental frame and galaxy millennium ii controller

Hide thumbs

Table Of Contents

Table of Contents

NE-M Installation Guide

Step

Connect and wire remote alarm output circuits to Connector J4. J4 is output alarm connector.

Utilize cable as necessary to obtain the desired connections to the outputs shown below.

Output Alarm Cable comcodes for J4 are: 50ft: CC848817635, 150ft: CC848817643.

Wire

BL/W

O/R

G/W

W/R

BK/R

Connect to network.

The controller provides an Ethernet connection for a LAN and or Craft port connection. Connector J5 provides a

standard RJ45 shielded receptacle connection for a standard Cat-5 connection to the controller's 10/100Base-T

port. This port has two main modes of operation: Server mode, LAN mode (Static and DCHP Client). In server

mode, the port can be used as a local Craft interface. In this mode, a local laptop can be connected through J5

and its standard web browser used to directly access the controller by typing in network address

http://192.168.2.1. A connection should never be made between the controller and LAN while the controller is in

Server mode.

Yes – go to Step 6.

Relays are reconfigured for specific use for specific Eco applications.

850050111

Issue 03 August 2017

Action – Pulsar Plus

Output Alarm Connector