Dynamics Section - DigiDesign D-Control Manual

Dynamics Section

The Dynamics section includes standard controls for compressor, gate, and limiter plug-ins, an array of controls for managing the
display and editing of plug-in parameters, and selecting or linking channels in multi-mono plug-ins.
Knee/Hysteresis
controls
auto
Knee Hyst
auto
Ratio Range
Ratio/Range
controls
D-Control Dynamics section
Dynamics Plug-in Support
Dynamics processing plug-ins may have widely varying con-
trols, depending on their applications. The D-Control Dy-
namics Section provides dedicated knobs and switches to ac-
commodate the widest range of plug-ins possible. Not all
plug-ins will require all the Dynamics controls, while others
may have more parameters than can be displayed in the Dy-
namics section at one time. To display all controls in any
plug-in, you can use Custom Fader Plug-ins mode.
Attack Gain/Hold
control controls
DYNAM
auto auto
Attack
L Lc
Gain Hold
Ls
Link
Page
auto auto
Ext Key
Release Threshold
Compare
Cycle
Release Threshold Dynamics Edit and Display controls
control control
Channel Select Low Filter
switches controls
Dynamics
Low Filter
DYNAM
auto
Frequency
C Rc R
Cs Rs LFE
Sel Link
Byp
auto
Listen Save As Lock
Q/Slope
Auto Safe
Master Byp Window Filt in
Displaying Dynamics Plug-ins
The D-Control Dynamics section automatically focuses the
first dynamics plug-in on the channel displayed in the Focus
Channel Strip on the Main Unit.
To display successive dynamics plug-ins that are on the fo-
cused channel, press the Cycle switch in the Dynamics sec-
tion.
High Filter
controls
Level controls
Hi Filter Gain Levels
Reduction
auto auto
Frequency Input
auto
Output
Clip
0 0
-1 -1
auto
-3 -3
Q/Slope -6 -6
-12 -12
-18
-18
-30
-30
-42 -42
Filt in C-L E-G Input
Gain Reduction Input and Output
meters
Chapter 7: Plug-in Controls 69
Output
meters