System Expansion Options; Operational Requirements; Connection Requirements; System Requirements - DigiDesign D-Control Manual

System Expansion Options

Fader Modules
Additional 16-channel Fader Modules can be added to D-Con-
trol, up to a total of 80 faders (five 16-channel Fader Modules).
Surround Panner Option
The Surround Panner option for D-Control work surfaces pro-
vides tactile control for many mixing and panning features to
enhance multichannel mixing for surround sound.
For details on D-Control expansion and customization op-
tions, visit the Digidesign Web site (www.digidesign.com).

Operational Requirements

Temperature and Ventilation
D-Control should be installed and operated in a climate-con-
trolled environment, away from heat sources, and with ade-
quate ventilation. D-Control should be operated at an ambi-
ent temperature that does not exceed 100 degrees F
(35 degrees C).
The back panel and the front half of the bottom panel of each
unit should be exposed to ambient air. Blocking or partially
blocking the back panel or bottom panel of a D-Control unit
may cause the unit to malfunction and may void your war-
ranty.
The D-Control stand is designed to provide adequate ventila-
tion for the D-Control units. Installation of D-Control units in
other stands or studio furniture is not recommended, and
may void your warranty if adequate ventilation is not main-
tained.
Water and Moisture
D-Control units should be operated away from sources of
moisture or humidity and should be kept clear of liquids that
might spill into the units.
Cleaning and Maintenance
If you need to clean the D-Control top surface, apply a
non-bleach cleaning solution to a cloth or paper towel, then
carefully wipe the surface. Do not use abrasives, cleaning so-
lutions with bleach, or spray cleaners.
4 D-Control Guide

Connection Requirements

Power Connections
Each D-Control unit (Main Unit and Fader Modules) and the
XMON Monitor Interface requires its own power connection.
Make sure your power source is correctly rated for the number
of units you are connecting. A surge protected power source
(not included) is highly recommended.
Ethernet Connections
Each D-Control unit communicates with Pro Tools via Ether-
net. A 10-BaseT Ethernet hub (not included) is required to
connect D-Control units to the host computer.
USB Connections
The computer keyboard and trackball on the D-Control Main
Unit require an available USB connector on the host computer
or on a USB hub if your system has one.
Audio Connections
All external analog audio inputs and outputs for control room
monitoring and studio communication are connected to the
XMON interface. D-Control connects to the XMON interface
with a single 15-pin cable (included). All analog inputs and
outputs on XMON are DB-25 connectors.
Audio Cables for D-Control Monitoring
Digidesign offers a range of DigiSnake cabling options for con-
necting Digidesign interfaces and external sources to the
XMON monitoring system. For details, visit the Digidesign
Web site (www.digidesign.com).

System Requirements

D-Control requires the following system components:
• Pro Tools|HD® system (which includes at least one
Pro Tools|HD audio interface)
An expanded HD-series system is required for higher track
counts.
For complete system requirements, visit the Digidesign Web
site (www.digidesign.com).
Compatibility Information
Digidesign can only assure compatibility and provide support
for hardware and software it has tested and approved. For a list
of Digidesign-qualified computers, operating systems, and
third-party devices, refer to the Digidesign Web site
(www.digidesign.com).