DigiDesign D-Control Manual page 68

Set To Default Switch
The Set to Default switch is used to reset parameters on the
D-Control surface to their default values. This switch works in
both Normal and Custom Fader modes.
Instead of using the Set To Default switch, you can
also hold the Alt key (Windows) or the Option key
(Mac) and press the corresponding switch to reset pa-
rameters to their default values.
The Set to Default switch can follow latching or momentary
behavior. If pressed briefly, it latches on and flashes until
pressed a second time. If held, its effect applies until released.
You can also use the Set to Default switch to remove
plug-in assignments from channels. See "Removing
Plug-in Assignments" on page 56.
While the Set to Default switch is pressed or latched on, the
following parameters can be reset:
To reset a channel's track volume to 0 dB:
Press Set to Default + the channel Select switch.
To reset a channel's pan control to 0 (center)
Press Set to Default + the pan encoder Select switch.
To reset a send's level to 0 dB:
Press Set to Default + the send encoder Select switch. This
sets the send level to 0 dB, regardless of the Send default set-
ting in Pro Tools Operation preferences.
To reset a channel's mic pre gain to 0 dB:
Press Set to Default + the mic pre gain encoder Select switch
To reset an LFE channel's gain to 0 dB:
Press Set to Default + the encoder Select switch for the LFE
channel.
To set a plug-in's parameters to their default values:
Press Set to Default + the Compare switch for the plug-in.
(The Compare switch appears in the D-Control Dynamics and
EQ sections, and in Custom Fader Expanded Plug-in mode.)
Suspend Groups Switch
The Suspend Groups switch suspends all groups in the session.
The Suspend Groups switch follows latching behavior, and
flashes to indicate groups are suspended. To exit Suspend
Groups mode, press the Suspend Groups switch again.
60 D-Control Guide
Global Channel Strip Mode Controls
The Global Channel Strip Mode controls are used to display
and edit pan, mic pre, insert, or send parameters across all
tracks in a session. These controls do not affect channel strips
in any of the Custom Fader modes.
Global Page Up
and Page Down
switches
Page Dn Page Up
Global Dynamics
switch
Dyn
Global Input
switch
Input
Global Inserts
switch
Inserts
Global Channel Strip Mode controls
Global Page Up and Page Down Switches
The Global Page Up and Page Down switches change the page
display on all channel strips.
To move the page display of parameters on all rotary encod-
ers up or down, press the Global Page Up or Page Down
switch.
Global Dynamics and EQ Switches
The Global Dynamics and EQ switches display the first
plug-in of the corresponding type on the rotary encoders
across all channels. To cycle through all the Dynamics or EQ
plug-ins across all channels, repeatedly press the correspond-
ing switch.
Global Input Switch
The Global Input switch toggles all applicable channels into
Inline mode (Audio and Auxiliary Input tracks) or to display
MIDI controls on the rotary encoders (Instrument tracks).
See "Inline Console Mode" on page 120 and "MIDI Controls
on Instrument Tracks" on page 50.
Global Mic Pre Switch
The Global Mic Pre switch displays the controls for re-
mote-controlled microphone preamplifiers on the rotary en-
coders across all channels.
Global EQ
switch
EQ
Global Mic Pre
switch
Mic Pre
Global Pan
switch
Pan
Global Sends
switch
Sends