DigiDesign D-Control Manual page 64

Assign Sends Switch
The Sends switch invokes Assign Sends mode, in which the
channel encoders shows the sends on a channel.
When assigning a send, the encoder Select switch is used to
navigate down through Send menu levels, and the encoder
knob is used to scroll through available choices at each level:
• Send type (Interface or Bus), shown in yellow
• Individual sends, shown in green
The Bypass/Mute/Pre switch on each encoder is used to navi-
gate back up the Send menu levels.
Assign Inserts Switch
The Inserts switch invokes Assign Inserts mode, in which the
channel encoders show the inserts on a channel. When as-
signing an insert, the encoder Select switch is used to navigate
down through Insert menu levels, and the encoder knob is
used to scroll through available choices. The Bypass/Mute/Pre
switch on the bottom encoder is used to navigate back up the
Insert menu levels.
The order in which plug-ins appear in the Insert menu is de-
termined by the Pro Tools Display preference for plug-in orga-
nization.
If the Organize Plug-in Menus by Category option is selected,
menu levels and choices include:
• Insert type (TDM plug-in, RTAS plug-in, Multi-Mono
TDM plug-in, Multi-Mono RTAS plug-in, or Hardware In-
sert), shown in yellow
• Plug-in subfolder (such as EQ, Dynamics, Pitch Shift, Re-
verb, and Delay), shown in yellow
• Individual insert or plug-in, shown in green
If the Organize Plug-in Menus by Category option is not se-
lected, the Plug-in subfolder level is not present.
To assign an input, output, send or insert:
Press an Assign switch to enter the corresponding Assign
1
mode.
On the channel where you want to make the assignment,
2
turn an encoder knob to select from the first level of menu
choices.
Press the encoder Select switch to move down and the By-
3
pass/Mute/Pre switch to move up through menu levels.
Do one of the following:
4
• Press the flashing encoder Select switch or press the flash-
ing Assign switch to confirm the assignment.
– or –
• Press the flashing Escape switch to cancel the assign-
ment.
56 D-Control Guide
To assign multiple inputs, outputs, sends, or inserts:
Press an Assign switch to enter the corresponding Assign
1
mode.
Turn the encoder knobs and use the encoder Select and By-
2
pass/Mute/Pre switches to select each assignment.
Do one of the following:
3
• Press the flashing Assign switch to confirm all the assign-
ments at once.
– or –
• Press the flashing Escape switch to cancel all the assign-
ments.
To remove an input, output, send or insert:
Press an Assign switch to enter the corresponding Assign
1
mode.
For the assignment you want to remove, press the encoder
2
Bypass/Mute/Pre switch repeatedly until you reach top level
menu for the assignment.
Turn the encoder knob counter-clockwise until no assign-
3
ment is visible.
Do one of the following:
4
• Press the flashing encoder Select switch or press the flash-
ing Assign switch to confirm the removal.
– or –
• Press the flashing Escape switch to cancel the removal
and restore the assignment.
Removing Plug-in Assignments
You can use the Set to Default switch to quickly remove
plug-in assignments from tracks, without having to go into
Assign mode.
This method removes the assignments immediately,
and cannot be canceled.
To quickly remove plug-in assignments:
Press the Set to Default switch.
1
Press the encoder Select switch for each plug-in assignment
2
you want to remove.
Press the flashing Set to Default switch.
3