DigiDesign D-Control Manual page 106

Automation Controls
AutoMatch Switch
The AutoMatch switch activates the AutoMatch command in
Latch or Write automation modes.
Join Switch
The Join switch is used in Latch mode to resume writing of au-
tomation on all channels that were previously writing auto-
mation, after an interrupted automation pass.
AutoJoin Switch
The AutoJoin switch is used in Latch mode to automatically
resume writing of automation after the transport is stopped
and started again during an automation pass.
Actions Switch
The Actions switch displays the following commands:
Actions Switch (Page 1)
Wrt To Start (Write To Start) Writes current automation val-
ues from the insertion point backward to the beginning of a
selection or track while performing an automation pass.
Wrt To All (Write to All) Writes current automation values to
an entire selection or track while performing an automation
pass.
Wrt To End (Write to End) Writes current automation values
from the insertion point forward to the end of a selection or
track while performing an automation pass.
Wrt To Next (Write to Next Breakpoint) Writes current auto-
mation values from the insertion point forward to the next
automation breakpoint while performing an automation pass.
Snap Back Causes all Latch or Write enabled tracks to exit
their current automation pass and return instantly to the pre-
viously written automation levels. During playback, stops
writing of automation without applying any AutoMatch
ramping.
98 D-Control Guide
Actions Switch (Page 2)
Wrt To Currnt (Write To Current Parameter) Writes the current
control value to the currently displayed automation parame-
ter (Edit > Automation > Write To Current).
Wrt To All Ena (Write To All Enabled Parameters) Writes cur-
rent control values to all enabled automation parameters (Edit
> Automation > Write To All Enabled).
Trm To Currnt (Trim To Current Parameter) Applies the current
trim value to the currently displayed automation parameter
(Edit > Automation > Trim To Current).
Trm To AllEna (Trim To All Enabled Parameters) Applies current
trim values to all enabled automation parameters (Edit > Au-
tomation > Trim To All Enabled).
Gld To Currnt (Glide To Current Parameter) Applies a transition
between automation values to the currently displayed auto-
mation parameter (Edit > Automation > Glide To Current).
Gld To AllEna (Glide To All Enabled Parameters) Applies a tran-
sition between automation values to all enabled automation
parameters (Edit > Automation > Glide To All Enabled).
Actions Switch (Page 3)
Copy To Send Opens the Copy To Send dialog to allow copy-
ing of track control values to each selected track's send (Edit >
Automation > Copy To Send).
Thin Auto (Thin Automation) Performs the Thin Automation
command. (Edt > Automation > Thin).