DigiDesign D-Control Manual page 29

Using a 3/16-inch hex wrench, attach the rear rail to the rail
7
tabs on each leg from below with 1/4-inch-20 x 1/2 inch
socket head cap screws (see Figure 13), using 2 screws in each
side. Make sure to leave the screws loose enough so that the
leg assemblies can be moved side-to-side relative to the rear
rail.
Figure 13. Attaching support rail from below
Locate the front pan support rail, which is the smaller of the
8
two rails provided with the stand.
Position the front rail so that the edge with the V-shaped
9
notch points toward the left stand leg.
Notch indicating left side of front pan support rail
Figure 14. V-shaped notch in front pan support rail
Lift the front rail into place so that the rail rests on the
10
front rail tabs of the stand legs. The holes on the ends of the
rail should line up with the slots in the front rail tabs on each
leg.
Using a 3/16-inch hex wrench, attach the front rail to the
11
rail tabs on each leg from below with 1/4-inch-20 x 1/2 inch
socket head cap screws, using 2 screws in each side. Make sure
to leave the screws loose enough so that the leg assemblies can
be moved side-to-side relative to the front rail.
Figure 15. Front and rear support rails in place on left stand leg
With the rear crossbar, rear support rail and front support rail
in place (see Figure 15), you are now ready to install the
D-Control units on the stand.
Chapter 3: Setting Up D-Control 21